Its option Take into account for depth ( introduced in version 0.19) will subtract the conical height from the Dimension. Type: defines the ending of the hole if Depth is set to Dimension.Countersink angle: angle of the conical hole cut.Depth: depth of the hole cut, measured from the sketch plane.Diameter: sets the upper diameter (at the sketch plane) for the hole cut.Type: sets type of hole cut: None means no cut, other types are different norms for screws ( introduced in version 0.19) and the two generic types Counterbore and Countersink.Note: For technical reasons, Through All is actually a 10 meter deep hole.
Through All will cut the hole through the whole Body.
Dimension enables a field to type a value.
#Floor generator remove holes iso
For ISO threads the diameters are according to the ISO 273 standard, for UTS they are calculated using a rule of thumb because there is no norm defining them. Clearance: sets either standard, close or wide clearance hole diameter.Requires Profile to be set to one of the ISO or UTS profiles. Direction: sets the thread direction (Right Hand or Left hand) if Threaded is checked.If it is used, it is advised to check it as one of the last actions done to the model, because it will increase recomputation time significantly. This consumes much computing power and is usually not used for models, except for display purposes or sometimes for 3D prints. Model Thread: if checked a real thread is modeled.If left unchecked, the hole is considered non-threaded, and the nominal major diameter with defined Clearance is chosen. Threaded: if checked threading data will be added to the Hole feature and the hole minor diameter is used.ISO and UTS thread profiles enable the Size fields. Profile: if set to None, no threading info is defined.Define the Hole parameters, that are described in section Options.ĭepending on which selection is made, some fields will activate or stay disabled.Alternatively, a sketch can be selected before launching the Hole command.
If more than one sketch is found, a Select feature panel appears to make a selection. If an existing unused sketch is found, it will be used automatically.Many parameters can be set such as threading and size, fit, hole type (countersink, counterbore, straight) and more.Ĭountersunk (to the left) and counterbored (to the right) holes longitudinal section. All non arc/circle entities are ignored but they still must form closed contours. If arcs are present they must be part of closed contours. Primarily heard in UK, Ireland.ĭocument.getElementById("tfd_idiom_div").style.The Hole feature creates one or more holes from a selected sketch's circles and arcs. Mind the gapAn audio or visual instruction used in the UK and Ireland to be careful stepping over the space between a train's carriage and the platform when boarding or disembarking.
#Floor generator remove holes code
Copy the code below and paste it where you want this content to be shown on your page or customize: